Notícias da indústria

Where is the integrated solar street light battery installed?

autor : Shenzhen Crown Lighting

tempo de atualização : 2021-06-25 11:38:52

Where is the integrated solar street light battery installed?

With the rapid development of technology and the continuous maturity of solar energy technology, solar LED street & safety lighting have gradually entered the market, even occupying a large share of the market. solar LED street and roadway lights are mainly composed of solar panels, intelligent controllers, batteries, LED street lamps, light poles and brackets. The batteries are equivalent to the "basement" or "logistics department" of solar LED Area and LED Street Lights, which store and supply energy. So where should the battery of the solar street light be installed? In response to this problem, the next step is to introduce the traditional and solar LED Roadway Lighting & Commercial Street Lights.

1. Surface
It is to put the battery in the box and place it above the ground and at the bottom of the intelligent and energy-efficient solar LED street lighting pole. I have to say that this method is easy to maintain later, but you need to be cautious about being stolen.

2. Buried
Dig a suitable pit in the ground next to the new solar LED lamps light street pole and bury the battery in it. This is a commonly seen method. The buried method can avoid the battery life loss caused by long-term wind and sun, but it is necessary to pay attention to the proper depth of the pit foundation, sealing and waterproofing.

3. On the street light pole
The battery is still installed in a specially built box and installed on the solar streets and highway lighting pole as a part. Because of the higher installation location, the possibility of theft can be reduced to a certain extent.

4. Below the solar panel
Put the battery in the box and install it on the top of the solar active LED street lights pole and the underside of the solar panel. The possibility of being stolen in this way is relatively small.

5. Directly fixed on the back side of the solar panel
Put the battery in the box and install it on the back side of the solar panel. The possibility of being stolen is even smaller, so it should be noted that the battery must be small and try to be a lithium battery.

6. The new type is directly installed in the frame on both sides of the lamp body
The battery is assembled in the frame on both sides of the lamp body. This installation method takes into account all the above advantages and improves the waterproof level of the battery pack, the balance of the weight of the whole efficient solar LED street lighting lamp, and the convenience of replacement.

The above are the installation locations of the innovative solar street lighting battery. The installation of general "Urban Light" solar street lamps require a professional powerful solar led street light construction manufacturer to conduct a site survey and issue a detailed lighting design plan. If the site does not have the underground conditions, it is still recommended Choose the ground method and the installation of all in one new solar LED streetlights is much more convenient, as long as the lamp and the pole are fixed correctly, it can be used normally.

Anterior : How to choose a cost-effective integrated solar street light?

Próximo : How to solve the waterproof problem of integrated solar street light?

Produtos relacionados

Holofotes LED Série ARF, UL/cUL/DLC 5.1 listados/TUV, 50W-500W, 5-10 anos de garantia, 100-480VAC, 140-160lm/W

► Aprovação UL/cUL/FCC/CE/RoHS
► DLC 5.1 Premium
► 0-10V Dimerizável / Sensor de Fotocélula Opcional
► 500W-500W, 140-160 lm/W
► IP65, 5-10 anos de garantia

Holofotes LED Série ARF, UL/cUL/DLC 5.1 listados/TUV, 50W-500W, 5-10 anos de garantia, 100-480VAC, 140-160lm/W

► Aprovação UL/cUL/FCC/CE/RoHS
► DLC 5.1 Premium
► 0-10V Dimerizável / Sensor de Fotocélula Opcional
► 500W-500W, 140-160 lm/W
► IP65, 5-10 anos de garantia

10W-60W SMD LED Down Light 110-150lm/w 5 anos de garantia 2700K-6500K 200-240VAC

► Sem cintilação
► Serviço personalizado disponível
► Uma lâmpada LED, quatro formas de instalação
► Molde exclusivo de CrowndaLED

25W-320W luzes de rua da série S7 (B) aprovadas pela FCC CE

► Alta eficiência: 130lm/W, 150lm/W e 170lm/W disponíveis.
► Lente PC antirreflexo, ângulo de feixe opcional: 60° / 90° / 120° / T2M / T3M / T4M.
► 0-10V regulável/controle de tempo/sensor de luz/controle lOT

Helen Helen Helen

Helen

Deixe um recado

Boletim de Notícias